The use of greenhouse film

Dec 01, 2022

The greenhouse film should pay attention to daily maintenance during use to avoid damage and rupture of the greenhouse film. The following are some problems that need to be paid attention to when using the greenhouse film. Attention to the care of the greenhouse film can effectively extend the service life of the greenhouse film.

 

The surface of the scaffolding material should be smooth. The main reason for the rupture of the greenhouse film is that the materials used for scaffolding the greenhouse, such as bamboo poles, iron wires, and aluminum wires, are hard and sharp to break the film. Therefore, the frame material must be smooth on the surface, and the pole tips and bamboo joints must be polished. The frame should be made of soft materials such as hemp rope and thread rope. Greenhouse films are all formed by splicing several narrow films. During splicing, the bonding area should be increased and the bonding strength should be improved. If the seam is too narrow and the bonding area is small, it will cause seams when pulled hard. After the greenhouse is covered with film, it should be pressed with film pressing line immediately. Generally, a film pressing line is pulled every 1-2 scaffolds, and the tightness of the line should be moderate, otherwise it will be easily blown under the attack of strong winds.

 

When the greenhouse film is out of service, dig a hole and bury it. During the collection of the film, it should be strictly prevented from exposure to the sun, smoke and fire, otherwise, its service life will be greatly shortened. Practice has proved that the best storage method for greenhouse films is to dig pits and bury them. After the production of the greenhouse is completed, the removed film should be washed and dried, improved or rolled, wrapped with the old film, dug a pit in a place with moderate soil humidity, and then put the wrapped film into the pit for burial. Note that the upper layer of the film should be more than 30cm away from the ground. This method can avoid agricultural film stored in the air due to aging and brittle, and shorten the service life.


You Might Also Like